I did make some additional changes, and I'm a bit unsure of which of these are redundant/not necessary but everything is working correctly right now as I want it, so I'm going to leave it be.changes I made are in screenshots below. I disabled Dynamic Routing, configured the Network Tag in the Meraki portal (don't know if this actually mattered but I did it anyway), and set the same config on both sides as Molan's above screenshots. Just wanted to chime in and say: I have matched Molan's settings and it is working for me.Ĭonfigured both sides of the tunnel with the same settings as Molan's screenshots. Which is supposed to give us the commands to input the code above, but we're not 100% sure about this part. We then were given this link Opens a new window However the challenge was how to input this into Using the example from number 6 from the link above The steps listed below in the link except number 5 and 6. We have configured the USG for Manual IPSec andĭynamic Routing is disabled. It didnt seem that complicated when molan posted their screenshots. This is what we came up with after following all the KBs. Got on live chat with Ubiquiti but they werent much help they just send over KBs. The meraki is sending out traffic in the packet capture but the USG is not responding. I'm on the phone with Meraki and they are saying the USG is not sending any traffic back.
0 Comments
Leave a Reply. |